DRIVE SELECTION
DRIVE SELECTION SWITCH REMOVAL/INSTALLATION:
1. Disconnect the negative battery terminal.
2. Remove the selector lever knob.
3. Remove the shift panel.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
| 1 | Drive selection switch connector |
| 2 | Screw |
| 3 | Drive selection switch |
DRIVE SELECTION SWITCH INSPECTION [(E)]:
1. Disconnect the negative battery terminal.
2. Remove the drive selection switch.
3. Measure the resistance between drive selection switch terminal B and C using a tester.
– If not within the specification, replace the drive selection switch.
L.H.D
| Switch condition | Resistance (ohm) |
|---|---|
| SPORT switch held at on | Approx. 0 |
| OFF switch held at on | Approx. 470 |
| any switch not pressed | Approx. 2,670 |
R.H.D:
| Switch condition | Resistance (ohm) |
|---|---|
| OFF switch held at on | Approx. 0 |
| SPORT switch held at on | Approx. 470 |
| any switch not pressed | Approx. 2,670 |
Relevant contents: