COOLING SYSTEM LOCATION INDEX, SERVICE WARNINGS, ENGINE COOLANT LEVEL INSPECTION AND WATER-COOLED CHARGE AIR COOLER COOLANT LEVEL INSPECTION [SKYACTIV-D 1.8]

COOLING SYSTEM LOCATION INDEX

1Coolant reverve tank
2Cooling system cap
3Water-cooled charge air cooler reserve tank cap
4Water-cooled charge air cooler reserve tank
5Radiator
6Electric water pump
7Coolant control valve
8Water pump
9Cooling fan component

COOLING SYSTEM SERVICE WARNINGS
Warning:
– If the cooling system cap or the water-cooled charge air cooler reserve tank cap is removed when the engine is hot, steam and boiling water may be injected, causing severe burns or severe injury. Perform the removal of the cooling system cap and water-cooled charge air cooler reserve tank cap when the engine is cool.
– Turn off the engine and wait until it is cool. Even then, be very careful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes.
– When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.
– Depending on the vehicle, the cooling fan may operate suddenly even when the ignition is off. Therefore, keep hands and tools away from the cooling fan even if the cooling fan is not operating to prevent injury to personnel or damage to the cooling fan. Always disconnect the negative battery cable when servicing the cooling fan or parts near the cooling fan.

ENGINE COOLANT LEVEL INSPECTION
Oil and Chemical Type
Engine coolant
Type: Recommended engine coolant
Warning:
– If the cooling system cap or the water-cooled charge air cooler reserve tank cap is removed when the engine is hot, steam and boiling water may be injected, causing severe burns or severe injury. Perform the removal of the cooling system cap and water-cooled charge air cooler reserve tank cap when the engine is cool.
– turn off the engine and wait until it cool. Even then, be very caraful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first top. Step back while the pressure escapes.
– when you are sure all the pressure is gone, press down on the cap using the cloth, turn it and remove it.

Steps:
1. Remove the cooling system cap.
2. Verify that the engine coolant is filled close to the top of the radiator filler neck.
– If the engine coolant is not filled close to the top, replenish the engine coolant after performing the engine coolant leakage inspection.

WATER-COOLED CHARGE AIR COOLER COOLANT LEVEL INSPECTION