Caution:
– Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. In addition, if there is any brake fluid on the wiring harness, the wire insulation may corrode causing a malfunction such as a short circuit. If brake fluid gets on a painted surface or wiring harness, wash and flush it off completely with water immediately.

Power brake unit removal installation:
1. Disconnect the negative battery terminal.
2. Remove the following parts:
– Windshield wiper arm and blade.
– Cowl grille.
– Windshield wiper motor and link.
– Side cowl grille.
– Cowl panel.
3. Remove the insulator.

Relevant contents:

•  Conventional brake system location and brake fluid [(e)]
•  Vacuum line and vacuum hose
•  Brake pedal, brake switch, master cylinder and brake fluid level sensor [(e)]
•  Vacuum pump [(e)]
•  Front brake [(e)]
•  Rear brake and maintenance mode [(e)]