Replacement part	Oil and chemical type
Gasket Quantity: 1 Location of use: Oil pan drain plug	Engine oil Type: Recommended oil

Procedure:
1. Park the vehicle on level ground.
2. Warm up the engine to allow the engine oil temperature to reach 60 °C {140 °F} or more.
3. Stop the engine and wait for 5 min or more.
4. Remove the oil filler cap.
5. Remove the service hole cover (installed to front under cover No.2) used to drain the engine oil.

7. Drain the engine oil into a container.
8. Wait until the engine oil starts to drip.
9. Replace the oil pan drain plug gasket with a new one and install.
The amount of residual oil in the engine can vary according to factors such as the replacement method and oil temperature. Verify the oil level after engine oil replacement.
10. Add engine oil according to the following engine oil capacity (reference).

11. Install the oil filler cap.
12. Start the engine and verify that there is no oil leakage.
– If there is oil leakage, repair or replace the malfunctioning location.
13. Verify that the engine oil amount is at the MAX position on the oil level gauge.
14. Install the service hole cover.
15. If the engine oil is replaced, perform engine oil data reset.