P001100 Camshaft Position “A” – Timing Over-Advanced or System Performance Bank 1
DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P001100 | Camshaft Position “A” – Timing Over-Advanced or System Performance Bank 1 | With engine warmed up and while driving in urban area (engine speed 4000 rpm or less), intake side valve timing does not change in advanced position, and target and actual valve timing do not match (1 trip detection logic). | Camshaft timing gear assembly·ECM | Comes on | DTC stored | SAE Code: P0011 |
CONFIRMATION DRIVING PATTERN
- Connect the GTS to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the GTS on.
4. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
5. Turn the engine switch off and wait for at least 30 seconds.
6. Turn the engine switch on (IG) [A].
7. Turn the GTS on.
8. Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher [B].
9. Drive the vehicle at approximately 60 km/h (37 mph) for 10 minutes or more [C].CAUTION:
When performing the confirmation driving pattern, obey all speed limits and traffic laws.
10. Idle the engine for 3 minutes or more [D].
11. Enter the following menus: Powertrain / Engine / Trouble Codes [E].
12. Read the pending DTCs.HINT:
· If a pending DTC is output, the system is malfunctioning.
· If a pending DTC is not output, perform the following procedure.
13. Enter the following menus: Powertrain / Engine / Utility / All Readiness.
14. Input the DTC: P001100.
15. Check the DTC judgment result.
| GTS Display | Description |
|---|---|
| NORMAL | · DTC judgment completed·System normal |
| ABNORMAL | · DTC judgment completed·System abnormal |
| INCOMPLETE | · DTC judgment not completed·Perform driving pattern after confirming DTC enabling conditions |
HINT:
· If the judgment result is NORMAL, the system is normal.
· If the judgment result is ABNORMAL, the system has a malfunction.
· If the judgment result is INCOMPLETE, perform steps [F] through [H].
16. Repeat the pattern of accelerating the vehicle from rest to approximately 60 km/h (37 mph) and then decelerating the vehicle 10 to 15 times [F].CAUTION:
When performing the confirmation driving pattern, obey all speed limits and traffic laws.
HINT:
Depress the accelerator pedal by a large amount.
17. Idle the engine for 3 minutes or more [G].
18. Enter the following menus: Powertrain / Engine / Trouble Codes [H].
19. Read the pending DTCs.HINT:
· If a pending DTC is output, the system is malfunctioning.
· If a pending DTC is not output, perform the following procedure.
20. Check the DTC judgment result again.HINT:
· If the judgment result is NORMAL, the system is normal.
· If the judgment result is ABNORMAL, the system has a malfunction.
MONITOR STRATEGY
| Required Sensors/Components (Main) | Camshaft timing gear assembly |
| Required Sensors/Components (Related) | Crankshaft position sensor Camshaft position sensor Engine coolant temperature sensor |
| Frequency of Operation | Continuous |